Watch Dog Timer - Albatron KX400+ Pro-C User Manual

Frequency / Voltage Control
This Mainboard automatically detects and recognizes the CPU ratio. You can
otherwise override these values using the BIOS setup.
Configuration the CPU Frequency using BIOS Setup
BIOS SETUP>>Advanced BIOS>>Features>>Frequency/Voltage Control>>CPU
Speed Detected
CPU Speed = CPU Ratio * CPU Clock
DDR Speed = DDR: CPU Ratio * CPU Clock
For more details, please refer to Frequency / Voltage Control in Chapter 2 BIOS
Setup.

Watch Dog Timer

This mainboard comes with a special feature called "Watch Dog Timer" which is
used to detect when the system is unable to boot using the manual over-clocking
configurations. After you power on the system, BIOS will check the last system
POST status. If it was successful, BIOS will enable the "Watch Dog Timer" feature
and set the CPU frequency values to the user configured values stored in the BIOS.
If unsuccessful the "Watch Dog Timer" will reboot the system.
Typically, you would need to remove the cover of your system and re-jumper the
clear CMOS switches on the mainboard when your system encounters over-clocking
problems. With the "Watch Dog Timer", overclocking settings will be automatically
cleared and reset.
Before Overclocking
Please make sure your system components are capable of overclocking.
If you are not familiar with the overclocking function, we strongly recommend
that you to set the clock to the default settings.
KX400+ series mainboard
15