Troubleshooting; Follow Case Is Not Problem - Samsung WA70Q3 User Manual

troubleshooting

TROUBLESHOOTING
Washing machine won't work
Is the water tap opened?
Is the washer plugged in?
Is the power cut off?
Is there enough water?
Is the fuse broken?
Is the Start/Pause button
pressed?
Water is not supplied
Is the water tap opened?
Is the water cut off?
Is the water supply hose or hose
connection clogged?
Is the water tap frozen?
If water is not supplied in 4
minutes, a buzzer will sound, and
the remaining time indicator will
show "4E".

FOLLOW CASE IS NOT PROBLEM

CASE
Change to Rinse
course,suddenly, when the
washer is in spinning course.
The water is not supplied,
and the pulsator rotate
repeatedly
When the spinning is
beginning, the spinning tub
rotate discontinuity
Start to supply water, in the
washing course
Before drain action, the
pulsator will rotate gently,cont
inuous,repeatedly
the local place on control
panel gently heat.
It's different between display
time and actual time
14_ troubleshooting
WA70Q3-DC68-02566D-EN-00.indd 14
When the laundry is unbalanced, the washer will change to rinse course automatically,
to adjust the laundry to a balanced situation, automatically, then resume spin. If this
unbalanced situation sitll happened, after above is runed ,the buzzer will sound, you
can open the washer door and put the laundry level.
After selecting the washing program and press "Start/Pause" button, the washer will
detect the laundry quantity and select water level, through rotating the pulsator,then
begin to supply water.
When spinning is beginning, the spinning tub start to spin slowly, then change quick.
This is a discontinuous spinning course, to avoid residual lather.
Micom will detect water level momently in the washing and rinse course, if the water
level is lower, the washer will start to supply water, automatically.
It will prevent the laundry unbalanced(if the laundry unbalanced,the abnormal noise
may take place).
If the power cord still plug in, the local place on control panel will gently heat. This
is a normal situation, don't worry about it. If you pull off the power cord plug, this
situation will disappear, automatically.
Every program actual running time is different from the PCB designing clock, because
the water pressure and power voltage and frequency is different in different area.
Water dose not drain
Is the drain hose down?(No pump)
Is the drain hose frozen?
Is the drain hose clogged?
If the water dose not drain in 15
minutes, a buzzer will sound, and
the remaining time indicator will
show "5E".
Spinning does not work
Is the laundry spread out evenly
in the washer?
Is the washer set on a sturdy flat
surface?
Is the lid colsed?
CAUSE
2009-4-30 14:05:45