Related Manuals for Gigaware 40-310
Summary of Contents for Gigaware 40-310
- Page 1 40-310 User’s Guide ® Alarm Clock Radio ® ® with Dock for iPod or iPhone Please read this user’s guide before using your new Alarm Clock Radio.
-
Page 2: Package Contents
Package contents • Alarm Clock Radio • AC Adapter • 5 Cradles with 2 Rubber Pads • Remote Control with Battery • User’s Guide • Quick Start Features • Docking clock radio for iPhone/iPod • WWi Certified • Playback music and recharge your iPod/iPhone at the same time •... - Page 3 AUX IN Connect an external audio source. DC 5V/2A +/– Plug in the supplied • Volume up/down. AC adapter. • Set the clock time and the alarm. FM Antenna • Press to turn on the clock radio and choose sound source (iPod/ FM/AUX).
- Page 4 MENU • Turn your clock radio on/off. Access the iPod menu. • Silence the alarm for 24 hours when the alarm MUTE sounds. Turn sound on/off. MEMORY Store radio stations. ALARM MODE Select Buzz/iPod/FM. ENTER • Confirm menu selection in iPod •...
-
Page 5: Use Your Clock Radio
Use Your Clock Radio Dock and Charge Your iPod/iPhone Insert the cradle that fits your iPod/iPhone model, then plug in your iPod/iPhone. The table below shows cradle markings (on the back of the cradle) and iPod/iPhone models. Notes: • When the iPod/iPhone is connected, it charges automatically. •... -
Page 6: Listen To Fm Radio
Listen to FM Radio Fully extend the FM antenna wire to get best reception. 1. Press G/F to turn on the clock radio. 2. Press G/F again or press FUNC on the remote to select FM mode. 3. Press or to manually tune to the next radio station. 4. -
Page 7: Set The Alarm
Clock Radio Settings Set the Clock Time 1. Press button on your clock radio to enter the time setting mode. The hour digits flash. 2. Press + or – to set the hour. 3. Repeat steps 1 and 2 to set the minutes. 4. -
Page 8: Replace Batteries
Snooze When the alarm sounds, press Z Z or SNOOZE/NAP on the remote to stop the alarm for 10 minutes. flashes in snooze mode. The clock radio goes back to the mode before the alarm activated. The alarm sounds again after 10 minutes. In standby mode: 1. -
Page 9: Specifications
2. Insert a new 3V, CR2025 battery, positive “+” side up. 3. Slide the tray back into the battery compartment until it clicks. Battery Notes: • Dispose of batteries promptly and properly. Do not burn or bury them. Use only fresh batteries of the required size and type. •... -
Page 10: Limited Warranty
Apple Inc., registered in the U.S. and other countries. Protect the environment by recycling used electronics. Go to E-CyclingCentral.com to find an electronic recycling center near you. © 2010. Ignition L.P . All rights reserved. Gigaware Printed 10A10 is a registered trademark used by Ignition L.P .