Installation - Desa Dual Brite PF-4125-AZ Manual

Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes,
turn the power off for 1
back on. After the calibration time the con-
trol will be in the AUTO mode.
D B
®
ual rite
Light comes on dim for selected time after
dusk (Off, 3 hr., 6 hr., until dawn). If motion
is sensed, the light turns on full bright for the
ON-TIME (1, 5, or 10 minutes) then returns
to dim mode.

INSTALLATION

Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Pliers
• Safety glasses • Light bulb
• Silicone caulk
For best performance, mount the fixture about
6 feet (1.8 m) above the ground.
WARNING: Turn power off at circuit
breaker or fuse.
ON-TIME Switch at 1,
5, or 10 minutes
Flip light switch
off for one second
then back on*
/ minutes, then
1
2
Dimmer Control
• Wire strippers/cutters
1. Remove two nuts.
SENS
MIN MAX
4. Set sensitivity control on back
5. Attach mounting
plate to junction box.
Horizontal Junction Boxes Only:
Fixture
Screw
Remove ground screw and 2 fixture screws
from the mounting plate. Flip plate over.
Re-insert ground screw. Insert the 2 fixture
screws in the holes near the junction box
screw holes. Wire path must be located as
shown above.
2
2. Remove
Mounting Plate.
3. Tighten screws
finger tight.
of fixture to mid-position.
Ground Screw
Wire Path
Wire
Path
Junction
Box
Screws
598-1166-03
Ground
Screw
Fixture
Screw