Washing Clothes Manually; Using Delay End - Samsung WD8602R8W Owner's Instructions Manual

Washing clothes manually

You can wash clothes manually without using the Fuzzy Logic feature.
To do so:
1. Turn the water supply on.
2. Press the
(On/Off) button on the washing machine.
3. Open the door.
4. Load the articles one at a time loosely into the drum, without overfilling.
5. Close the door.
6. Put the detergent and, if necessary, softener or prewash detergent, in the appropriate
compartments.
7. Press the Temperature button to select the temperature.
(cold(0˚C), 30˚C, 40˚C, 60˚C and 95˚C)
8. Press to rinse button to select the required number of rinse cycles.
Maximum number of rinse cycles is five.
The washing duration will be prolonged accordingly.
9. Press the Spin button to select the spin speed. [ 0, 400, 800, 1000, 1200 revolutions per
minute(rpm)]
Notice: The rinse hold program allows you to take clothes that are dripping wet out of the
washing machine.
0 : No spin , Non display : Rinse hold
10. Press the button repeatedly to cycle through the available delayed start options (from 3 hour to 19
hours in one hour increments). Displayed hours means the time of finished washing-cycle.
11. Press the Start/Pause button and the machine will begin the cycle.

Using Delay End

You can set the washing machine to finish your wash automatically at a later time, choosing from 3 to 19
hour delay (in 1 hour increments). Displayed hours means the time of finished washing-cycle.
To do this:
1. Manually or automatically set your washing machine for the type of clothes you are washing.
2. Press the Delay End button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay End indicator will light, and the clock will begin counting
down until it reaches your finish time.
4. To cancel Delay End, press the
WD8602R8-02410Z_EN.indd 4
Washing a Load of Laundry
(On/Off) button, then turn the washing machine on again.
SAMSUNG Washing Machine Owner's Instructions B-4
2009-01-09 ¿ÀÈÄ 6:20:36