Care And Cleaning; Cleaning The Brewer Housing; Cleaning The K-Cup ® Holder; Cleaning The My K-Cup - Breville BKC600XL User Manual

BR9013 BKC600XL_IB_AMEND.qxp

Care and cleaning

Before cleaning, ensure the Brewer has been turned
off. Switch off at the wall outlet, unplug the power
cord and allow the machine to cool.

Cleaning the brewer housing

Regular cleaning of the Brewer's housing and
external components is recommended.
1. Never immerse the Brewer in water or other
liquids. Wipe the housing with a soft, damp
cloth then dry thoroughly.
Do not use abrasive scouring pads or cleaners
when cleaning the housing as they may scratch
the surface.
2. The Drip Tray and Drip Tray Plate can accumulate
up to 12 oz. of overflow. The water level indicator
visible through the Drip Tray Plate will pop up
when this occurs. The Drip Tray and Drip Tray
Plate should then be removed, emptied and
cleaned. To remove the Drip Tray assembly, slide
it toward you, keeping it level at all times to
avoid spilling. Wash both parts in warm soapy
water with a soft cloth, then rinse and dry
thoroughly. The Drip Tray and Drip Tray Plate are
also top-shelf dishwasher safe.
Cleaning the K-Cup ® Holder
Regular cleaning of the K-Cup ® Holder is
recommended.
1. Raise the Safety Locking Arm and remove the
K-Cup ® Holder from the Brewing Chamber (refer to
Brewing with the My K-Cup ® Accessory, page 12)
2. Disassemble the K-Cup ® Holder buy pulling
downwards on the Funnel located at the base of
the Holder.
22
11/10/07 21:43 Page 22
3. Wash both parts in warm soapy water with a
soft cloth, then rinse and dry thoroughly. The
Note
K-Cup ® Holder and Funnel are also top-shelf
dishwasher safe.
The K-Cup ® Holder houses a needle in the inside
base. Should a clog arise due to coffee grinds, it
can be cleaned using a paper clip or similar tool.
Insert the paper clip into the Needle to loosen the
clog and push it out. To avoid risk of injury, do not
put your fingers in the K-Cup ® Holder.
4. After cleaning, place the Funnel back onto the
K-Cup ® Holder.
5. Place the assembled K-Cup ® Holder back into
the Brewing Chamber, aligning the arrow
on the K-Cup ® Holder with the arrow
the Brewing Chamber. Use caution when doing
this as there is a sharp needle on the underside
of the Brewing Chamber Head that punctures the
K-Cup ® .

Cleaning the My K-Cup

Regular cleaning of the My K-Cup ® accessory is
recommended.
1. Remove the assembled My K-Cup ® Holder from
the Brewer by raising the Safety Locking Arm. Use
caution as the My K-Cup ® Holder will be hot.
Note
in
®
accessory
2. Disass
the Lid
directi
Holder
3. Wash
soapy
thorou
shelf d
4. Store
My K-
of the
Cleaning
1. Wipe t
then d
into th
2. Wash
soft cl
dry the
remain
the dis
Rinse th
ensure t
remain a
supply in
Cleaning
Regular cle
We sugges
replaced e
1. Disass
Lower
Discar
2. Wash
soapy
thorou
dishw