Timer; Sleep; Recall; Child Lock - Daewoo 2594ST Instruction Manual

In the MAIN MENU, Select TIMER menu.
SETTING THE CLOCK
Press the button on the CLOCK line.
Set the hours and minutes with the NUMBER button 0..9 Press the OK but-
ton to complete. The clock will start.
Note that if you turn the TV off with MAIN POWER button, the clock setting
is lost and must be reset if necessary.
SETTING THE WAKE UP TIME
Set WAKE UP TIME in a same way to the above for CLOCK.
Set ACTIVATE "YES" or "NO" with the LEFT/RIGHT button.
When ACTIVATE is "YES", the function is enabled.
Set WAKE UP PROG using the NUMBER button 0..9 or UP/DOWN button.
When WAKE UP TIME is operate, the set will switch on to this programme
number.
By pressing the SLEEP button repeatedly, you can select one of the follow-
ing setting:
0->30min. ->60min. ->90min. ->120min. ->0
The set will turn off after time you select.
Automatic Switch-Off in No broadcast Signal
If a broadcasting signal is not present for about 5-30 minutes, the set will be
automatcally turned off.
In AV mode, however, this function dose not operate.
The RECALL button is used to diaplay the current status: programme num-
ber, station name and clock.
This display appear for 5 seconds unless any button is pressed.

CHILD LOCK

You can prevent the use of the TV set without the remote control.
The set is child-locked after switching off the set by pressing the Y, C, TELE-
TEXT( ), POWER button (
seconds. The child-lock function is indicated by flashing the STAND-BY
INDICATOR. The set can only be switched back on using the remote con-
trol.
Pressing the TIME button, the current time is displayed on the screen dur-
ing 5 seconds. If the programme you are watching has no Teletext transmis-
sion, no time will be displayed.
The MODE button is used to change the sound mode. During a stereo
transmission, pression the button will change from stereo to mono.
Pressing this button again will change it back to stereo.
During a bilingual programme transmission, pressing the MODE button will
change the language to the sound channel. Pressing again will change it
back to the main channel.
There may be case of stereo broadcasts where excessive noise will be
heard due to weak incoming signal. You may be able to eliminate this noise
by selecting the MONO mode.
8

TIMER

SLEEP

RECALL

) in sequence on the remote control within 5

TIME

MODE

TIMER
CLOCK 12:20
WAKE UP TIME --:--
ACTIVATE YES
WAKE UP PROG P 45
TIMER
CLOCK 12:20
WAKE UP TIME 7:00
ACTIVATE YES
WAKE UP PROG P 45