INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed
•
#2 Phillips and flat-blade
•
Knife
screwdriver
•
Safety glasses
•
Adjustable wrench that
•
Duct tape
opens to 1 in. (2.5 cm) or
%6 in. open-end wrench
•
Caulking gun and
(for adjusting dryer feet)
compound
(for installing
new exhaust vent)
•
Level
•
V4in. nut driver or socket
•
Gloves
wrench
•
Pliers
•
Wood block(for
leveling)
•
Scissors
•
Ruler or measuring tape
•
Tin snips (for new vent
•
Wire stripper (direct wire
installations)
installations)
Parts supplied
Remove parts package from the washer basket. Check that all
parts were included.
Parts listed are available from your local Sears store or Sears
Service Center. Please reference the service numbers located on
the back page of this manual.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller than
available)
96 in. (2.4 m)
1 in. (2.5 cm)
2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe
diameter standpipe adapter, Part
Number 3363920
Overhead sewer
Standard 20 gal (76 L) 34 in. (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets
2 longer water fill hoses:
beyond reach of fill
6 ft (1.8 m) Part Number 76314,
hoses
10 ft (3.0 m) Part Number 350008
4
6
5
1. Water inlet hoses (2)
2. Inlet hose flat washers (4)
3. Front leveling feet with nuts (2)
4. Shipping strap (net in parts bag, see
"Remove Shipping Strap")
5. Drain hose
6. Yellow, single wire hose clamp
7. Silver, double-wire
hose clamp
7
Parts needed
Check local codes, electrical supply and venting, and read
"Electrical Requirements"
and "Venting Requirements"
before
purchasing parts.
Mobile home installations require
•
Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.
Explosion
Hazard
Keep flammable
materials
and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion,
or fire.
You will need
•
A location that allows for proper exhaust installation. See
"Venting Requirements."
•
A separate 30 amp circuit.
•
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the laundry center. See "Electrical
Requirements."
•
A sturdy floor to support the laundry center weight (laundry
center, water and load) of 500 Ibs (226.8 kg).