Table of Contents
Advertisement
74
To install an expansion card
Note: The illustrations used in this section show the Altos G510
server chassis.
1
Observe the ESD precautions and pre-installation procedures
described on page 36.
2
Locate an empty expansion slot on the mainboard.
3
Loosen the bracket screw on the rear panel.(1).
4
Pull out the card bracket (2).
5
Remove the expansion card from its protective packaging.
6
Align the card in the empty slot on the mainboard. Make sure that
the card is properly seated.
7
Insert the bracket with the card into the selected slot (1).
3 Upgrading the system
Advertisement
Table of Contents
