Threading The Machine; Setting The Needle - White 1066 Instruction Manual

6. THREADING THE MACHINE
Place a spool of thread on
spool
pin and raise the take-up
lever to its highest point Refer to(Fig. 8)
Pull thread through slot of upper thread guide (1) down
through tension discus(2)up into thread check spring (3) and
i4) and on up into the eye of the takeup lever (5) from right
to left.
Return thread through middle thread guide (6) down through
lower thread guide (7) and into needle bar thread guide (8)
Thread needle from left to right, pulling about four inches
of thread through needle.
7. SETTING THE NEEDLE
1. Turn the balance wheel towards you, raising needle bar
to its highest position, and loosen the needle clamp screw.
2. Hold the needle in the left hand with the point down
and insert the needle up into the needle clamp as for
as it will go with its flat surface to th right ther1retight
en the clamp screw (Fig. 9).
Ne'dIo
Fig 8
Need'e
bar
Fiat
uraC
Need'e
ba
head
guide
SCi i2W
—1—
Thread
Fig 9