Setting Up Your Machine; Foot Control; Power/Light Switch; Opening Front Cover - White SuperLock Instruction Manual

SETflNG UP YOUR MACHINE
1. Set your machine on a sturdy, flat surface.
2. As your machine has been thoroughly oiled
at the factory, be sure to wipe the needle
plate area and bed plate carefully before
sewing a garment. It is wise to practice on a
scrap of fabric so any surplus oil is absorbed.
3. FOOT CONTROL
Push foot control plug into the connector
socket at the bottom right-hand side of
the machine.
4. POWER/LIGHT SWITCH
Your machine will not operate
unless
the
power/light switch is turned on. This
same switch controls both the machine
power and sewing light. When leaving
your machine unattended, the machine
MUST be switched off or the plug
removed from the socket-outlet.
When
servicing the sewing machine,
removing covers or changing lamps, the
machine MUST be disconnected from the
supply by removing the plug from the
socket-outlet.
5. OPENING FRONT COVER
To open front cover, pull it towards you as
illustrated.
It will latch automatically when closed.
6. OPENING AND CLOSING SIDE COVER
1. Raise presser foot by presser foot lever.
2. Pull release lever towards you.
3. To close side cover, just push it back.
5