Advertisement
S S
/ / A A
S S
P P E E A A K K E E R R
M M P P L L I I F F I I E E R R
E E L L E E C C T T O O R R
devices, provided a "low-voltage partition" is used between
the devices. We do not recommend this. Speaker wires can
act as an "antenna" for electrical noise. Locating speaker
wires too close to a light switch or dimmer may cause a
"popping" or "buzzing" sound to be heard through the
speakers. If you must locate the ABA-1D near electrical
devices, install it in a separate metal electrical box, ground
the box to the electrical system ground, and route the speak-
er wires several feet away from the electrical wiring.
Changing the Color of the ABA-1D
The Decora insert and button on the ABA-1D are removable,
allowing fast and easy color changes as needed. Inserts and
buttons are available in a variety of colors.
If you need to change the color of the ABA-1D:
1. Obtain the ABA-1D Decora insert and button in the
desired color from your Niles dealer.
2. Holding the ABA-1D as shown in (Figure 1), locate the
two plastic mounting tabs at the top rear of the Decora
insert. Using two fingers, simultaneously press both tabs
down (towards the center of the insert) and forward (away
from you) until the insert pops free from its mounting
slots.
3. Hold the ABA-1D as shown in (Figure 2). Remove the
5
Advertisement
