Surface Operation; Oven Light - Wolf Dual Fuel Ranges Use & Care Manual

SURFACE OPERATION

Oven Light

WARNING
Verify power is disconnected from electrical box before
replacing light bulb.
Allow oven to cool completely, then remove oven racks and
rack guides. To remove the light cover, gently pry bottom
edge with a flat screwdriver. Remove existing bulb and
replace with a 20-watt halogen bulb. Refer to the illustration
below.
LIGHT
COVER
Light bulb replacement.
Surface Burners
To light a burner, push and turn the corresponding control
knob counterclockwise to HI. The igniter will begin to click
until burner is lit. Once lit, continue to turn knob counter-
clockwise to desired setting.
To select a simmer setting, turn control knob to the detent
at the lowest setting. Push and continue to turn counter-
clockwise. The flame will transition to the second tier on
the burner cap. Continue to turn knob to desired simmer
setting.
During a power outage, surface burners can be lit manually.
Turn knob to HI and light using a multi-purpose lighter.
CAUTION
Never leave pans on a high setting unattended. Be
careful when cooking food in fat or grease; it can
become hot enough to ignite.
|
wolfappliance.com 13