Electrical Information; Intellifire Plus™ Pilot Ignition System Wiring - Outdoor Lifestyles CARDOG36IL Owner's Manual

6 6

Electrical Information

A. IntelliFire Plus™ Pilot Ignition System Wiring
• This appliance is equipped with an intermittent pilot ignition
(IPI) control which operates on a 6-volt system.
• This appliance is supplied with a battery pack which is
located in the control box. A wiring diagram is shown in
Figure 6.1.
• The battery pack requires four batteries (not included).
• An optional electric kit is available. This allows the system
to be operated with 110/120 VAC instead of batteries. See
Section 6.B.
• The appliance comes standard with an OFF/ON switch
on the control box lid
• Optional RC100 wireless wall switch (OFF/ON). For use
only with the optional electric kit.
• Optional RC200 wireless remote allows fl ame adjustment
(AUX200 is not required since there is no fan used). For
use only with the optional electric kit.
Valve
Figure 6.1 Intermittent Pilot Ignition (IPI) Wiring Diagram - Battery Power Only
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Carolina • 4066-300 • Rev. U • 3/12
Hearth & Home Technologies recommends that IntelliFire
TM
Plus
functionality with the IntelliFire Plus
NOTICE:
elements.
• The module should be in the REMOTE position. Putting
the switch in the OFF position will disable all fi replace
controls.
WARNING! Risk of Shock!
type 105° C rated wire. Wire must have high temperature
insulation.
WARNING! Risk of Shock!
nection when servicing controls. Wiring errors can cause
improper and dangerous operation. Verify proper operation
after servicing.
Pilot
assembly
Module
WHT
Wiring
harness
Jumper
wire
External Control Switch
(Isolates batteries from system to increase battery life)
BLK
wireless controls be used for their features and
RC100 & RC200 must be protected from the
Replace damaged wire with
Label all wires prior to discon-
ORG
Battery
holder
TM
ignition system.
13