Removing The Eoc Assembly - Whirlpool RS160LXT Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug range or disconnect power.
2. Pull the range forward so you can access
the two end cap screws.
3. To remove the electronic oven control
(EOC) assembly on slide-in models:
a) Remove the two screws from the sides
of the left and right end caps.
Screw
End Cap
b) Open the oven door and remove the
indicated screws from the bottom of
the control panel.
Control Panel Screws

REMOVING THE EOC ASSEMBLY

Left
c) Pull out on the bottom of the control
panel, unclip the top edge from the
bracket, and rotate the control panel
forward and down so you can access
the components.
d) Disconnect the wire connectors from
the electronic oven control board at P1,
P2, P3 and P4.
e) Remove the four screws from the elec-
tronic oven control housing, and remove
the assembly from the control panel.
NOTE: The EOC boards and the hous-
ing are replaced as an assembly.
P1
4-2
P2
P4
P3
EOC Housing
Screws