USSC APS1100B Owner's Manual page 5

Flue Collar
(Stove Back)
Fig. 6
APS1100 Assembly
Fig. 5
Side view of flue collar
mount to heater top
This heater comes equipped with a cast-iron
flue collar to mount as shown below:
Flue Collar
5/16-18 x 1-1/2" Bolts (3 req.)
Weld Tab (3 req.)
Gasket
Peel off tape from the back of the gasket and
attach the gasket to the rope groove in the flue
collar. Mount flue collar to the top of the heater
using the (3) 5/16-18 x 1-1/2" Bolts, Washers,
and the (3) Weld tabs provided in the parts
bag.
KEY DESCRIPTION
1 Blower Motor
2 Blower Housing Front
3 Blower Housing Back
4 Power Supply Cord
5 Rheostat w/Nut and Knob
6 Strain Relief Bushing
N/S 10AB x 3/8 Hex Zinc Screw
N/S #12 x 3/4 Teks Screw
ASSEMBLY INSTRUCTIONS
Step 1.
THE BLOWER ASSEMBLY MUST BE DISCON-
NECTED FROM THE SOURCE OF ELECTRICAL SUP-
PLY BEFORE ATTEMPTING THE INSTALLATION.
With pliers, cut the 4 tabs and remove panel on the
back of the stove. Note: Discard the panel.
Step 2.
Fix the assembly to the back of the stove with the
four screws provided.
THE BLOWER ASSEMBLY IS INTENDED FOR USE
ONLY WITH A STOVE THAT IS MARKED TO IN-
DICATE SUCH USE.
DO NOT ROUTE THE SUPPLY CORD NEAR OR
ACROSS HOT SURFACES!
5
PART NO. QTY.
80442 1
25090B 1
25089B 1
80232 1
80090 1
80109 1
83222 8
C23799 4