IBM 10/100 EtherJet User Manual page 29

Command Description
Sn Control S register:
Sn?: Read the S register n?, where n=0-110.
Sn=r: Set the S register n to value r (n=0-110, r=0-255).
T Select tone dialing.
V DCE response format:
Control the result code format.
V0: Displays result code as digits.
V1: Displays result code as text (default).
W Result code option:
W0: CONNECT result code reports DTE receive speed. Disable protocol result codes.
W1: CONNECT result code reports DTE receive speed. Enable protocol result codes.
W2: CONNECT result code reports DCE receive speed. Enable protocol result codes (defaults).
X Result code selection and call progress monitoring:
Control the tone detection option used in the dialing process.
Ext. Result Code Dial Tone Detect
X0
X1
X2
X3
X4
X5
X6
X7
Y Long-space disconnect:
Long space disconnect is always disabled.
Y0: Disable long space disconnect (default).
Y1: Enable long space disconnect (NOT SUPPORTED).
Z Reset and recall stored profile.
&B V.32 auto retrain:
This modem always auto retrains.
&B0: Disable V.32 auto retrain (NOT SUPPORTED).
&B1: Enable V.32 auto retrain (default).
&C Data carrier detect (DCD) control:
&C0: Specifies that carrier detect (CD) is always on.
&C1: Turns on CD when the remote carrier is present (default).
&D Data terminal ready (DTR):
&D0: Ignores the DTR signal.
&D1: Return the modem to command mode after a DTR toggle.
&D2: Hangs up the modem and returns to command mode after a DTR toggle (default).
&D3: Resets the modem after a DTR toggle.
&F Local factory settings:
Loads the factory default configuration.
&G V.22bis guard tone control:
Determines which guard tone to transmit while transmitting in the high band.
&G0: Disable the guard tone (default).
&G1: Enables a 550-Hz guard tone.
&G2: Enables a 1800-Hz guard tone.
Disable Disable
Enable Disable
Enable Enable
Enable Disable
Enable Enable
Enable Enable
Enable Enable
Disable Enable
Busy Tone Detect
Disable
Disable
Disable
Enable
Enable (default)
Enable
Enable
Enable
Advanced information
19
Using the modem