10
ASSEMBLING AND PREPARING
Using the IR Receiver
This allows a remote control sensor to be placed
in a custom location. The IR receiver is made
with a magnet. Attach the magnetic sheet to the
desired position on the product. It is recommended
to attach it to the location illustrated in the figure
below.
Portrait Layout
To install in portrait mode, rotate the set
counterclockwise 90 degrees when looking at from
the front.
Using the Kensington security system
The Kensington security system connector is
located at the back of the monitor set. For more
information of installation and using, refer to the
manual supplied with the Kensington security
system or visit http://www.kensington.com .
Connect the Kensington security system cable
between the monitor set and a table.
NOTE
The Kensington security system is optional.
y
y
You can obtain additional accessories from
most electronics stores.