Cisco Catalyst 2960-S Started Manual page 25

Catalyst 2960-S Switch Getting Started Guide
Note
Install the SFP or SFP+ Modules
Step 1 Grasp the module on the sides, and insert it
into the switch slot until you feel the
connector snap into place.
Step 2
Insert an appropriate cable into the module
port. Insert the other cable end into the other
device.
Caution
OL-19793-02
The automatic medium-dependent interface crossover (auto-MDIX) feature is
enabled by default. The switch detects the required cable type for copper Ethernet
connections and configures the interfaces accordingly. Therefore, you can use
either a crossover or a straight-through cable for connections to a copper 10/100
or 10/100/1000 module port on the switch, regardless of the type of device on the
other end of the connection.
Some Catalyst 2960-S switches have SFP module slots and others have SFP+
module slots. The SFP slots support only the SFP modules. The SFP+ slots
support both SFP and SFP+ modules.
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the
documentation that came with the SFP module.
Removing and installing an SFP module can shorten its useful life. Do not remove
and insert SFP modules more often than is absolutely necessary.
C a ta ly
47X
48X
Catalyst 2960-S Switch Getting Started Guide
s t 2 9 6 0
-S
Se rie s P o E + 1
0 G
1
2
C a ta ly
s t 2 9 6 0
-S
Se rie s P o E + 1
0 G
47X
48X
1
2
25