Advertisement
2. Remove Valve Assembly
On a Novus 30 in. appliance (GNDC30 or GNBC30 only) the
valve assembly must be raised slightly to allow the fan to be
moved past it to the back of the appliance.
3. Install the Fan
Position the fan all the way to the rear and center in the ap-
pliance. Press the fan (magnets to the bottom) to the back of
the appliance. See Figure 7. Plug the fan cord into the fan
receptacle labeled "FAN" on the junction box. See Figure 8.
4. Install the Control Module
Attach the control module to the bottom pan using the mag-
netic tape provided.
5. Wiring the Fan Control Module
Note: Fan control timer only for use on units with junction
box pictured in Figure 9.
•
Robertshaw Valve (Standing Pilot)
-
Connect the black, white and red wires with 1/4 in.
female connectors from the fan control module to the
appliance junction box as shown in Figure 9.
-
Connect the black ground wire with the ring terminal
to the TP screw on the valve (center).
-
Remove wall switch wire connected to valve terminal
marked "TH".
-
Connect the black with white stripe wire with 3/16 in.
piggyback connector from fan control module to valve
terminal marked "TH".
-
Connect wall switch wire removed from valve terminal
"TH" to the piggyback connector on the black with white
stripe fan control module wire.
Note: Thermopile must be wired as shown in Figure 9.
RS
Valve
Figure 9
Robertshaw Wiring Diagram
Hearth & Home Technologies • GFK21B Fan Kit • 4016-096 Rev I • 11/08
Figure 7
Figure 8
Fan
Control
Module
FIREBOX
BOTTOM
FAN
BOTTOM PAN
Rotate Fan
Fan Assembly
Junction Box
Position the Fan
Wall
Switch
White
Red
Black
APPLIANCE
BACK
Cord
Clips
3
Advertisement
