Connecting The Antenna - NetComm NF2 FIBRE SERIES Quick Start Manual

Fibre series dual band wifi gigabit hub

Hide thumbs Also See for NF2 FIBRE SERIES:

Table of Contents

Connect the supplied antenna to the circular antenna port on the back of the NetComm

NF2. This should be attached onto the port in a clockwise direction.

If connecting by Ethernet WAN, connect an RJ-45 Ethernet cable from the blue WAN port

of the NF2 to one of the Ethernet LAN Ports on your modem/Fibre termination point.

If connecting by 3G/4G, connect your USB modem to the 3G/4G USB port on the side of

the router.

Connect the supplied power adapter into a wall socket and switch on the power.

Connect the power adapter to the NF2 and press the on/off button to power the router on.

Allow up to 60 seconds for the router to boot up.

Connecting the antenna

and cables

Antenna

Modem/Fibre ONT

Table of Contents