NetComm NF2 FIBRE SERIES Quick Start Manual
Fibre series dual band wifi gigabit hub
Hide thumbs
Also See for NF2 FIBRE SERIES:
- User manual (69 pages) ,
- Setup manual (32 pages) ,
- Manual (15 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NetComm NF2 FIBRE SERIES
Summary of Contents for NetComm NF2 FIBRE SERIES
- Page 1 NETCOMM FIBRE™ SERIES Dual Band WiFi Gigabit Hub NF2 - Quick Start Guide...
-
Page 2: Connecting The Antenna
Antenna Modem/Fibre ONT Connect the supplied antenna to the circular antenna port on the back of the NetComm NF2. This should be attached onto the port in a clockwise direction. If connecting by Ethernet WAN, connect an RJ-45 Ethernet cable from the blue WAN port of the NF2 to one of the Ethernet LAN Ports on your modem/Fibre termination point. -
Page 3: Ethernet Cable
Connecting to the router via an Ethernet cable Computer Connect an RJ-45 Ethernet cable from one of the yellow Ethernet LAN Ports on the back of the NF2 to the LAN port of your computer. Wait approximately 30 seconds for the connection to be established... -
Page 4: Login To The Web Interface
Login to the web interface Open a web browser (Internet Explorer, Firefox and Safari), type 192.168.20.1 into the address bar and press Enter/Return. At the login screen, type “admin” (without the quotes) into both the Username and the Password fields and click “OK”. The “First-Time Setup Wizard”... - Page 5 Router Setup - WAN If connecting to an ADSL modem or a Fibre termination device, select “WAN” as the WAN interface. Select “Dynamic IP Address” as the WAN type and press the “Next” button. To enable a backup connection via 3G/4G, tick the checkbox and enter the appropriate 3G/4G connection information as supplied by your 3G/4G provider (see the instructions on Step 5 of this quick start guide).
- Page 6 Router Setup - 3G/4G Select your country of residence and your service provider from the dropdown boxes and the network name (APN) will automatically appear. Enter your username/password and SIM PIN if required as supplied by your 3G/4G provider. Not all 3G/4G providers require a username and password or a SIM PIN Click “Next”...
- Page 7 Completing the wizard 2.4GHz WiFi Select to enable or disable your wireless network (Wireless on/off), show or hide your wireless network (SSID Broadcast) or change the wireless network name (SSID Broadcast Name). After making the appropriate changes, click “Next”. (If you do not want to change the default settings, simply click “Next”) Select the wireless security type and wireless security key you would like to use on your wireless network and click “Next”.
- Page 8 Enter the username and password you would like to use when logging into the web based user interface. Confirm the new password by entering it a second time in the “Retype Password” field and click “Next”. (If you do not want to change from the default settings of admin/admin, simply click “Next”) Review your selected settings and click “Finish”.
-
Page 9: Connecting Via Wifi
Connecting via WiFi 5 GHz 2.4 GHz Laptop Gaming Console IPTV Smart Phone You can connect multiple wireless devices, including laptops, desktops and PDA’s to your router by following these two basic steps. Using your wireless device, scan the wireless networks and select the wireless network name listed on the included Wireless Security Card and then click connect. -
Page 10: Usb Storage
USB Storage USB storage device 1. If a USB mass storage device is plugged into the File Storage USB port, it will be auto detected 2. You can access the files on the storage device from any computer connected to the router 3.