Hunter Internet Thermostat Installation Manual page 6

4. Reconnecting Your Wires
Raise the appropriate terminal levers.
Lift the levers on the terminals that match the
labels on your wires. If one of the terminals
you need has a shield in front of it, use your
finger to break the tab away.
Insert your wires and lower the levers.
Insert each wire into its corresponding
terminal. Lower the levers and push any
excess wire back into the wall.
If you only have an RH wire,
leave the pre-installed jumper clip in
place between the RC & RH terminals.
Install the wire under the jumper clip in the
same opening.
If you have both an RC & RH wire,
lift the RC & RH levers and remove
the pre-installed jumper clip now.