Getting Started - Hunter Internet Thermostat Installation Manual

Getting Started

You will need a Phillips head screwdriver to complete this installation.
Tip: You may need a precision screwdriver (smaller tip) to detach wires from your old thermostat.
1. Power OFF Your HVAC System Unit
Turn Power
OFF
If you still need assistance after reading this manual, call our Technical Support at
This thermostat is compatible with most 24V AC/millivolt systems with a maximum of 1 amp including: conventional oil,
gas, electric, hot water systems, single stage, and multi-stage heat pumps. This thermostat will not control line voltage
systems running 110V. Higher amp or line voltage systems will increase the risk of fire.
*This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
*This device complies with RSS-GEN IC: Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
*Any alteration of this product, either intentional or unintentional, not expressly approved by the manufacturer could result in operation
failure of the device, inability to gain assistance from our technical team, or manufacturer refusing warranty support.
Go to your circuit breaker panel and turn off
power to your compressor and furnace.
Read and save these instructions!
USA: 1-888-830-1326 Canada: 1-866-268-1936
*This Class B digital apparatus complies with Canadian ICES-003.