Removing A Memory Module - Lenovo ThinkServer RD240 Hardware Maintenance Manual

Note: If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly installed. Open the retaining clips, remove the memory module, and then reinstall it
into the slot.
Figure 10. Installing the memory module
7. To complete the installation, go to "Completing the parts replacement" on page 86.

Removing a memory module

Attention
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that comes with your product, and
Guidelines. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove a memory module.
To remove a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See Removing the server cover.
3. Locate the memory slot with the memory module that you want to remove. See Locating parts on the
system board for the locations of the memory slots.
4. Carefully open the retaining clips on each end of the memory slot and then grasp the memory module
straight up by its edges.
40
ThinkServer RD240 Hardware Maintenance Manual