Front.wheel.mount; Front.wheel.bearings; Deck.spindle; Transmission - Husqvarna RZ3016 / 966612301 Operator's Manual

Front Wheel Mount
Lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out.
Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Bearings
Lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out.
Use only good quality bearing grease.
IMPORTANT INFORMATION
Use minimal lubrication and remove excess
lubricant so that is does not come into contact
with belts or belt pulley drive surfaces.
Deck Spindle
Lower the cutting deck completely.
If you use grease gun without rubber hose, remove
the foot plate to access deck spindle zerk.
Lubricate with a grease gun, one zerk, 2-3 strokes.
Use only good quality bearing grease.

Transmission

The transmission is maintenance free with no need for
level checks or oil changes. If a leak occurs, replace
the unit or contact your Husqvarna dealer.
Steering Control Shafts
Tip the driver's seat.
Lubricate with a grease gun, one zerk for each
steering control shaft, until the grease is forced out.
Use only good quality molybdenum disulphide
grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Engine Lubrication
Refer to the engine manufacturer's manual for
maintenance and service instructions.
42
LUBRICATION
Lubricating the wheel bearings
Lubricating the deck spindle after removing the foot plate
Lubricating the steering control shafts
8050-009
8050-027
8058-076