Gear Lever; Power Steering - Renault SENIC Handbook

GEAR LEVER

To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring 1 has to be lifted up to the gear
lever knob to select reverse gear.
The reversing lights will illuminate
as soon as reverse gear is selected
(ignition on).
2.06
HANDBRAKE
To release:
Pull the lever up slightly, press
button 2 and then lower the lever to
the floor.
The red warning light on the
instrument panel will illuminate if
you are driving with an incorrectly
released handbrake.
To apply:
Pull the lever up.
The lever should travel about 10
notches to hold the car. Your vehicle
is fitted with self-adjusting rear
brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
When the
stationary, make
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating
occur.

POWER STEERING

When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
vehicle is
sure
may
general (power steering and
brake servo will not function).
Never switch off the
ignition when travelling
downhill, and avoid
doing so when driving in