Setting Alarm; Using The Alarms - Bose Wave Radio Owner's Manual

Setting Alarm 1
Function
To set the Alarm 1 time - On the control panel, hold down ALARM
SET and press TUNING up or down. The time display changes slowly at
first, then more quickly. Release TUNING to stop.
On the remote, press TIME. The ALARM indicator flashes. Press
TUNING up or down. The time display changes slowly at first, then
more quickly. Release TUNING to stop. Press TIME to return the display
to the current time.
Note:
You can set the alarm with the radio on or off.
To turn on the Alarm 1 function - Press ALARMMODE
J'
.»))
in
sequence to select the mode you want: tone, radio, both tone and
radio, or off.
For tone only, press until the
.»))
indicator lights.
For radio only, press until the
J'
indicator lights.
For tone and radio, press until both indicators
J'
.»)
light. When the
alarm goes off, the tone sounds. Press SLEEP/SNOOZE to turn the
radio on. Press SLEEP/SNOOZE to pause the radio for 10 minutes.
To turn off the Alarm 1 function - Press ALARMMODE
J'
.»)
until the display shows no Alarm 1 mode indicators.
To check the Alarm 1 setting - On the control panel, hold down
ALARM SET to see the wakeup time.
On the remote, press TIME to see the wakeup time. Press TIME again to
return the display to current time.
-=-:~i
Contr61panel
(ALARM)
SET
< l·( >
TUNING
SLEEP/SNOOZE
"f.'l)
(ALARM)
SET
Remote control
( TIME
( <
TUNING>
To wake to a preselected radio station with Alarm 1 - While
holding ALARM SET, press the PRESET button for the station you want
(change between AM and FM if needed).
(ALARM)
SET
Use the control panel
to select this feature.
Using the alarms
To stop the alarm - Press ON/OFF. The indicators remain lit.
Or, if you do not stop the alarm, it shuts off in 30 minutes.
The alarm automatically resets to repeat daily.
To pause the alarm for 10 minutes - Press SLEEP/SNOOZE or
SLEEP to have the radiQ
J'
or tone
.»)
alarm repeat in 10 minutes.
When the alarm is in radio and tone
J'
.»))
mode, press SLEEPISNOOZE
or SLEEP to pause the tone and hear the radio.
To set the volume of the radio alarm - The radio alarm turns on
and gradually increases to the last volume setting used. You can select
a volume setting with the radio on or off.
To set the volume of the tone alarm - The tone alarm turns on
and gradually increases to the last tone setting used. You can set a
louder or softer tone by pressing VOLUME up or down while the tone is
sounding.
To use the alarm during a power failure - Press ON/OFF to
silence. The backup battery runs the alarm for approximately three days
without AC power. To conserve power, only the tone alarm sounds even
if radio alarm is selected. Normal operation resumes when power is
restored. Replace the 9V battery after an extended power failure.
12
Control panel
•
SLEEP/SNOOZE
T
)
(
•
VOLUME
T
) (
•
VOLUME
•
Remote control
•
G
... VOLUME •
1
... VOLUME •
)
•