Figure 3-4 Set The Ip Network Settings Automatically Or Manually; Table 3-4 Ip Network Device Setting Options - Honeywell HD3HDIH User Manual

HD3 EQUIP Series H.264 Indoor High Resolution True Day/Night IP Dome Camera User Guide
Option
Device Name
MAC Address
IP Address
Subnet Mask
Default Gateway
Document 800-07361V3 Rev A
11/2011
Table 3-4 IP Network Device Setting Options
Description
By default, the device name is the device type plus the MAC Address. Honeywell
recommends, for security, that you change the device name.
The MAC address is a factory-assigned address that is unique for each device.
The IP address of the device on the network.The camera obtains an IP address
by static or dynamic (automatic) means. There are two ways: Dynamic
(DHCP/APIPA), which is automatically assigned by the network administrator, or
Static (static), which is assigned by the user.
The subnet mask, or netmask, value of the device on the network. IP networks
can be divided into several smaller networks by subnetting. When a network is
subnetted, you must specify a subnet mask, which tells network devices which
smaller network they belong to.
Note If the subnet mask is not properly configured, the camera might not be
able to communicate with other devices on the network.
The default gateway address that connects the device to the network. Enter the
host IP address to use as a gateway between networks. The gateway allows
communication between devices that are on different networks. Without a correct
gateway setting, the camera cannot receive or transmit data from or to devices
that are not in the same network address range.
Figure 3-4 Set the IP Network Settings Automatically or Manually
Updating IP Network Settings Automatically
1. In the Discovery pane, select the device and click Connect
2. From the System tab click the Obtain an IP Address automatically check box.
3. Enter a Device Name, for example,
Click to clear this checkbox to
manually set the network details
FrontLobbyDome01.
.
39