Table of Contents
Advertisement
3.
Press SET to start the white balance tracing.
4.
When the white balance tracing is completed, release the
SET key and remove the white surface from in front of the
camera.
D/N
This function allows the camera to automatically switch from a
color camera to B/W camera by either auto detecting the
luminance, manual switching, or by the external contact
terminal's IR Lamp connection on the camera rear panel.
Fuzzy
The camera switches to a B/W camera by auto detecting
luminance.
C/K
Auto: removes burst signal when the camera changes to
B/W. OFF: keeps the burst signal when the camera changes to
B/W mode.
D/N Level
selects the detection level at either High or Low.
Time
sets the time (from 5 to 60 seconds) before the camera
switches to B/W after detecting a low light condition.
AGC Boost
ON: switches night mode to AGC Max Gain. OFF:
switches night mode to AGC Day Gain.
IR Pass
The camera switches to B/W immediately upon selecting this
function.
Burst On
keeps the Burst signal when the camera switches
to the B/W mode.
Burst Off
removes the Burst signal when the camera
switches to the B/W mode.
IR Cut
Disables the Day/Night function and keeps the camera in color
mode only. In this mode the camera will not accept any IR
luminance.
RS485
Before operating this function, make sure the correct RS485
connection is made on the rear panel.
Rev 1.01
15
900.0355
01/06
Advertisement
Table of Contents
