Tact Switch Operation; Opening The Set Up Menu - Honeywell HCD484E User Manual

Tact Switch Operation

This camera uses a Set Up Menu that is displayed on a
connected monitor. To set items in the Set Up Menu, use the
following buttons located in the side panel.
Figure 9
Left
Up Key This button is used to move the cursor upwards.
Down Key This button is used to move the cursor
downwards.
Right Key This button is used to move the cursor to the right.
Use this button to select or adjust the parameters of the
selected item. The parameter changes each time this button is
pressed.
Left Key This button is used to move the cursor to the left.
Use this button to select or adjust the parameters of the
selected item. The parameter changes each time this button is
pressed.
Set Key This button is used to set the determined parameter.
If the item has its own setting menu (indicated by ), press this
button to display the next page of the setting menu.

Opening the Set Up Menu

1. Press and hold SET for 3 seconds. The Set Up Menu will
appear on the monitor as shown in
Figure 10
Rev 1.01
Side Panel Buttons
Up
Down
Set Up Menu
Set Up Menu
Sync
Shutter
Lens
BLC
Configure
Cam Title
White Bal
D/N
RS-485
Exit Cancel
Right
Figure
Int
1/50
Bright
Off
Aperture
Off
WB-Auto
Fuzzy
Setting
Reset
9
Set Key
10.
900.0355
01/06