Mitsubishi Electric PAR-U02MEDA Instruction Book page 51

2
Touch the [Mode] button to select one of the
following energy-save control modes that reduces
energy-consumption during vacancy.
The default setting is "Non-use."
• Non-use: Deactivates the energy-save control
assist function.
• Thermo-off : Puts the unit into the Thermo-off
*1
state.
• Set temperature offset
• Fan speed down
*3
• ON/OFF: Turns off the unit.
*1 When using the energy-save function of other system
controllers in combination with the energy-save control
assist function of the Smart ME Controller, do not
select "Thermo-off" or "Set temperature offset."
*2 When the units are operated in the Fan mode, or
when the set temperature setting is prohibited from the
centralized controller, the set temperature will not be
offset.
*3 If the connected indoor unit does not support the
fan speed adjustment function, this item will not be
displayed.
When the occupancy sensor detects occupancy
during the energy-save control, the original
operating status will be restored.
However, when the operating status is changed
by other controllers or by the scheduled or timer-
controlled events, the current operating status will
be retained even if the occupancy sensor detects
occupancy.
<Note>
• To use the energy-save control assist function in a
system with both main and sub remote controllers,
activate the function only on the remote controller
whose coverage area is the largest.
Function settings
: Offsets the set
*1*2
temperature.
: Sets the fan speed to "Low."
51