Installing the DIMM on a PERC H700
CAUTION:
PERC H700 Modular cards, shipped in PowerEdge blade systems,
have an integrated DIMM module which cannot be removed. Do not attempt the
following procedure on a PERC H700 Modular controller card.
1 Unpack the DIMM and follow all antistatic procedures.
NOTE:
installing the DIMM.
2 If the DIMM support is not mounted onto the DIMM, perform the
following steps to replace the DIMM support before mounting on a
PERC H700:
With the old DIMM removed from the controller, press out on
a
the DIMM support clips inserted through the DIMM rotating the
DIMM support out of the DIMM. See Figure 4-9.
Figure 4-9. Removing the DIMM Support From the DIMM
1
DIMM
To mount, place the top edge of the DIMM support over the top edge
b
of the DIMM so that the arms on the side of the DIMM support fit
into their sockets on the DIMM. See Figure 4-10.
Do not use excessive pressure on the connector on the DIMM while
1
2
DIMM support
Installing and Configuring Hardware
2
53