Table of Contents
Advertisement
• Channel 19: Trucker channel in France, Spain and Italy (in AM).
• Channel 40 Calling channel in Switzerland- please do not use for data
transmission near to the Switzerland border line!
Programming one of the 5 direct channel buttons
You can re-programme each of the 5 numbers of the memory positions to any
desired channel (e.g. private channels or club channels):
• Choose when in normal modus the desired channel and the modulation
mode AM or FM (where allowed).
• Press the M button briefly (ME for Memory Enable appears on the display)
• Within the next 5 seconds press the desired direct channel button (1 to
5)
The desired channel is now stored on the direct channel button selected. You will see
both channel number (large) and direct button number (small) in the display.
Switching back to normal channel selection
Simply turn the rotary knob or press up or down on microphone.
•
The display of direct button numbers disappears and the channel selection works
•
again via microphone or rotary knob.
Channel scan
Your AE 5090 XL has an automatic channel scan, which can be used for all channels
and for the stored direct channel numbers.
First choose the mode of operation (normal channel modus or MEMO modus).
Adjust the muting control to the point at which the receiver should open (see also
'Adjusting squelch').
Start channel scan
Briefly press the button SCAN.
•
SCAN appears on the display and the channel scan starts almost immediately by
•
scanning all the channels down the frequencies.
The scan is stopped at each signal worth receiving and you can listen in to the
•
conversation.
If You leave the set alone it will re-start the scan after about 5 seconds and continue
to search for channels in use.
Stop channel scan
You can stop the scan at any time by pressing the SCAN button a second time.
•
Pressing the transmission button will also automatically stop the scan modus.
•
Change direction of scan
As a special function of the AE 5090 XL You can also change the direction in which
scanning takes place:
Press the ∨ button on microphone during the scan or turn the rotary knob slightly
•
to the left: the scan direction will change, i.e. from higher to lower channel
numbers.
Channel scan among direct channels
Switch Your set to MEMO modus by pressing one of the 5 direct channel keys.
•
12
Advertisement
Table of Contents
