Husqvarna 966529101 Operator And Parts Manual page 9

6
MOUNTING COVER ASSEMBLY
TO SUPPORT ASSEMBLY
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
1. Position cover assembly on the ground behind the
mower.
2. Lift and rotate cover to align the frame bracket
with the support assembly and slide the cover
down until secure.
Support
Assembly
7
INSTALLING CHUTES
1. Place middle chute over the top end of the blower
assembly. Stretch the chute latch on the blower
assembly up and onto the acorn nut on the middle
chute.
2. Slide the upper chute discharge end into the
hood inlet and fit the lower end over middle chute.
Secure as in Step 1.
Acorn Nut
Blower
Latch
ASSEMBLY
8
INSTALLING SPACER PLUG
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet. Replace the plastic end cap back over
the spacer. The additional extension will hold
the hood more securely when latched.
Cover
Assembly
Frame
Bracket
Insert spacer and
replace cap
9
CONTAINER INSTALLATION
1. Install containers on support frame, overlapping
containers at center tube.
NOTE: One container should always overlap the
other container at the center tube.
2. Close cover and lock latch handle over support
tubes.
8063-076
Remove center
end cap
Support
Frame
Latch
Handle
9