Husqvarna 966529101 Operator And Parts Manual page 7

1
BAGGER SUPPORT ASSEMBLY
1. Using four shoulder bolts from the kit hardware,
secure the support assembly to the drawbar
Support Assembly
Shoulder
Bolts
When removing the support assembly—pull
outward on the stop bracket to release it from and
the drawbar and slide support assembly up.
ASSEMBLY
Drawbar
8063-069
Support
Bracket
8063-070
2
MOUNTING BLOWER ASSEMBLY
1. Remove the discharge chute from the deck.
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Position blower over the discharge tabs on the
deck and set blower onto the deck.
5. Be sure the blower is sitting flush against the
outside of the deck.
Rear Mount Bracket
Contact Area
6. Install the front mount bracket to the deck with the
pin and hairpin cotter supplied with the kit.
Outer Pulley
Cover
8063-072
Hairpin Cotter
Pin
8063-073
7