Fujitsu SERVIS IP-KVM User Manual page 29

8. The following is displayed. Confirmed that the DHCP is disabled.
---------------------------
SERVIS IP-KVM Network Setup
---------------------------
NOTE: This interface is used to set network parameters and perform
certain recovery procedures, but the majority of setup and
configuration can only be done using the web interface.
Primary Ethernet Port (LAN)
D.H.C.P.: Disabled
IP Address: 192.168.0.2
Netmask: 255.255.255.0
Gateway: Disabled
Broadcast: 192.168.0.255
Machine name: noname
Default Gateway: <none>
Commands (press one key, then Enter):
D - Enable DHCP for dynamic IP address.
I - Set IP address.
N - Set netmask.
G - Set network gateway.
B - Set broadcast address (optional).
M - Change machine name (DHCP client name).
H - Reset/disable firewall, TCP ports, SNMP, RADIUS.
F - Reset everything to factory defaults.
S - Change system admin password.
P - Send ICMP ping packets (testing purposes).
? - Show TCP/IP ports and servers enabled.
V - Show Firmware Information.
R - Revert to current settings (undo changes).
>>> W - Commit changes to configuration.
Q - Logout.
NOTE: Your changes are still pending.
Choice:
9. Specify the IP address. Enter "i" in the "Choice:" prompt.
Choice: i
Enter↵
10. Current IP address is displayed in square bracket. Enter the new IP address
and press the [Enter] key.
IP Address [192.168.0.8]: 192.168.0.100
11. Specify the subnet mask. Enter "n" in the "Choice:" prompt.
Choice: n
Enter↵
12. Current subnet mask is displayed in square bracket. Enter the new subnet
mask and press the [Enter] key. Press the [Enter] key if the subnet mask is not
changed.
Netmask [255.255.255.0]: 255.255.255.0
2.2 Set the IP Address (For Initial Installation)
(00:0e:00:ee:04:03)
Enter↵
Enter↵
SERVIS IP-KVM
17
1p Converter
User's Guide
2