Selecting The Listening Position; Adjusting The Listening Position; Adjusting The Level Of The Subwoofer(S) - Sony XDP-210EQ Operating Instructions Manual

Selecting the listening
position
— Sound Control Mode
You can set the time for the sound to reach the
listeners from the speakers.
The unit can simulate a natural sound field so
that you can feel as if you are in the center of
the sound field wherever you sit in the car.
1 2
3
1
EN
Press (SOUND) momentarily until "POS"
appears.
POS
All
SUR EQ
2
Rotate/press (+) or (–) to select the
desired listening position.
The listening positions appear in the order
shown above.
After three seconds, the display goes back to
the normal playback mode.
Tip
To adjust the listening position further, press (SOUND)
for two seconds within three seconds after following step 2
above. Then go to step 4 to 8 of "Adjusting the listening
position."
Adjusting the listening
position
— Sound Tuning Mode
Note
When you adjust the listening position, set the balance and
fader control to the center position.
1
Press (SOUND) for two seconds.
2
Press (SOUND) repeatedly until "POS"
appears.
3
Rotate/press (+) or (–) repeatedly until
the desired listening position appears.
POS Tuning
All
SUR EQ
6
Actual total number:
Display Center of
window soundfield
Normal setting
ALL
(1 + 2 + 3)
Front part
FRONT
(1 + 2)
FRONT R Right front (2)
Left front (1)
FRONT L
Rear part (3)
REAR
4
Press (4) (n).
POS All
L R
SUR EQ
5
Rotate/press (+) or (–) to adjust the
center of the sound field to the left or
right. Then set the center of the sound
field.
(+): Center moves to the R (right).
(–): Center moves to the L (left).
6
Press (4) (n).
POS All
R F
SUR EQ
7
Rotate/press (+) or (–) to adjust the
center of the sound field to the front or
rear.
(+): Center moves to the F (Front).
(–): Center moves to the R (Rear).
8
Press (SOUND) for two seconds.
When the listening position setting is
complete, the normal playback mode
appears.
Adjusting the level of the
subwoofer(s)
— Sound Control Mode
You can adjust the subwoofer level
independently of the speakers.
1
Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).
2
Press (SOUND) repeatedly until "SUB"
appears.
SUB 1 0
SUR EQ
3
Rotate/Press (+) or (–) to adjust the
level.
After three seconds, the display goes back
to the normal playback mode.
Tip
To adjust the cut-off frequency of the subwoofer(s), press
(SOUND) for two seconds within theree seconds after
following step 3. The go to step 3 to 4 of "Adjustin the cut-
off frequency."
Sony XDP-210EQ (E) 3-856-153-12 (1)