Remington PG6060 Manual page 4

ENGLISH
C HOW TO USE
, Attaching and removing guide combs
• With the trimmer blade facing away from you, slide the guide comb over the back of
• With the trimmer blade facing away from you, carefully push the guide comb away
, Before you begin
Comb facial hair with a fine comb before you start trimming. Hairs should be dry and without
any waxes or lotions before using the groomer.
, To thin and taper beards or moustaches
• Attach the wide trimmer blade.
• Place the hair length attachment on the trimmer blade, select the desired length and
• Start trimming under the chin, following the jawbone line. Work toward the ear and
, To Trim edge of beards or moustaches
• Attach the detail trimmer blade.
• Hold groomer with cutting blade facing you.
• Start with edge of beard/moustache line, and with the cutting blades resting lightly
, To trim sideburns
• Hold groomer with cutting blade facing you.
• Use a small comb to lift the hairs. Hold the comb at the desired beard or moustache
• Move the groomer along the comb to cut the hairs. Use light pressure and
, Trimming the nape of your neck
• Attach the wide trimmer blade.
• Use your fingers to lift the hair at the base of your head up off the neck. Your index
• Using your other hand, hold the groomer to the base of your neck with the cutting unit
4
PG6060-INT-T22- SS2013 amended.indd 4
the trimmer blade and click into position.
from the wide head trimmer.
switch on.
upper beard line using an upward motion.
against your skin, use slow movements to create a beard/moustache line.
length.
well-controlled movements to trim hair.
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by groomer.
facing up, and move the groomer up the length of the neck until the unit touches your
finger covering the hair roots at the base of your head. Move the unit slowly when
performing this operation and to keep the hair roots at the base of your head out of the
way of the groomer.
11/21/2012 2:09:02 PM