Ventilation Requirements - Candy CDV 262 User Instructions

ENGLISH
Installation and

Ventilation requirements

1
SUPPLY CORD
AIR INLET
VENTS
IMPORTANT: This dryer must be
installed such that the air inlets and
outlets are not restricted (fig. 1).
There should be a gap of at least 12 mm
(0.5 inches) between the sides and rear of
the machine and the surrounding walls and
cabinets.
To ensure adequate ventilation the space
between the bottom of the machine and the
floor must not be obstructed.
NEVER install the dryer up against
curtains.
Prevent items from falling or collecting
between the sides and rear of the dryer as
these may obstruct the air inlet and outlets.
A venting hose is supplied with this
tumble dryer.
The use of the venting hose to exhaust hot
air to the external atmosphere is strongly
recommended to ensure maximum drying
efficiency. Protect the external outlet from
4
HOT AIR
OUTLET
prevailing winds to ensure back-draughts
do not reduce the drying performance.
If the dryer is installed under a worktop or
built-in, it is essential to use the venting
hose to carry the hot moist air away from
the dryer otherwise re-circulation of the
moist air will prevent the dryer from
working efficiently.
The hose may be fitted through a wall or
through an open door or window (fig. 2).
The hose is 95 mm (3.75 inches) in
diameter and will extend up to 1.8 metres
(6 feet).
Venting hoses longer than 1.8 metres
(6 feet) are not recommended as the dryer
performance will be reduced.
Ensure that the venting hose is not
kinked as this will prevent the dryer
from working efficiently.
2