Table of Contents
Advertisement
Filling the rinse aid container
4
3
FULL
EMPTY
dark
light
3
On the right of the detergent container the
rinse aid container can be found: it has a
capacity of about 130 ml. (Fig 9 "D"). Turn the
cap (3) anticlockwise and pour the liquid that
will last several washes, up to the maximum
level shown. Replace the cap.
The rinse aid, which is automatically released
during the last rinsing cycle, helps the dishes
to dry quickly and prevents the formation of
spots and stains.
It is always advisable to use rinse aid.
It is possible to check the rinse aid level through
the indicator eye which is situated in the centre
of the dispenser (4).
Regulating the rinse aid from 1 to 6
The regulator is placed under the cap (3) and
can be turned using a coin. The recommended
position is 3.
The limestone content of the water considera-
bly affects the formation of scale and the drying
performance.
It is therefore important to regulate the quantity
of rinse aid to achieve good washing results.
If, after the wash, streaks occur on the dishes,
decrease the amount by one position. If whitish
spots occur, increase the amount by one posi-
tion.
56
Water softener adjustment
Hardness
of water
regenerator
Level
F French
Degrees
1
0 - 16
*2
17 - 35
3
36 - 49
4
50 - 59
5
over 60
Water softener
According to the area, tap water contains a
variable amount of mineral and calcareous
salts which deposit on dishes leaving stains
and white deposits.
The higher the concentration of these salts,
the harder the water.
This machine is provided with a water softener
which uses a specific regenerator salt which
softens the water for dish-washing purposes.
The water softener can treat water with hard-
ness between 16 and 60 F (French degrees)
by means of five different settings.
The local Water Board can supply the degree
of hardness of the water in your area.
The following table illustrates the level
corresponding to the hardness of the water of
your area and indications as to necessary
setting adjustments:
Use of
Water
Machine
Softener
Adjustment
salt
Adjustment
NO
NO
NO
YES
NO
NO
YES
NO
YES
YES
NO
YES
YES
YES
YES
* The water softener is set by the factory at
level 2 as this satisfies most user requirements.
If the water in your area is at level 1, it is not
necessary to use regenerator salt or carry out
any adjustments since the water is already
soft.
57
Approx.
No.
Washes
50
40
30
20
Hide quick links:
Advertisement
Table of Contents
