Table of Contents
Advertisement
Installation
Mains Cable
In the event of damage to the appliance's main cable,
to avoid risks only an authorised service company
recommended by the supplier or a qualified person
may adjust it.
Unpacking
Unpack the appliance and check that it is in good
condition and free of any transport damage. Notify
the dealer immediately of any damage. Hand the
packaging over for recycling.
Do not allow children to play with the
packaging. The plastic film can cause
suffocation.
Removing the transport supports
Remove the tape and the transport supports from
·
the door sides
·
inside the door hinges
·
the shelves
Remove the transport support on the glass shelf by
pushing the support forward along the edge of the
shelf until it stops. Take hold of the rear edge of the
glass shelf and pull the shelf and transport support
forward until the shelf tilts and the transport support
can be removed. Some models are fitted with a
silencing pad under the appliance. Do not remove
this pad.
Installing the appliance
To obtain the best performance from the appliance,
ensure :
·
the appliance is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the applianceis not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the appliance is level. The appliance should not
lean
against any wall. If necessary adjust the
feet using the adjustment spanner supplied.
·
there is good air circulation around the appliance
and that the air channels below and behind
the appliance are not blocked. The ventilation
space above the appliance must be at least 4 cm.
The ventilation space can either be
a) directly above the appliance, or
b) behind and above the top cupboard. In this case,
the space behind the cupboard must be at least
50 mm deep.
10
Zanussi 818 20 92-00/0
Advertisement
Table of Contents
