Table of Contents
Advertisement
Installation
The floor must be clean and dry, free from floor polish
and other greasy substances, so that the machine
does not slide about. Do not use any grease as
lubrification.
Installation on deep pile carpets and floor
coverings with foam backings is not recommended,
as the stability of the machine is no longer guaran-
teed. If the installation must be done on a carpeted
floor, the openings located at the lower part of the
back of the appliance must remain free. These
openings ensure a good ventilation of your appliance.
In case of small format tiles, place a standard rubber
mat under the machine.
With sprung floors, in particular wooden plank floors
with yielding floor boards, screw down a waterproof
wooden base at least 15 mm thick, across at least 2
floor boards. Wherever possible, place the appliance
in the corner of the room - there wooden floors are
most secure and least liable to resonance vibrations.
Never compensate for small unevennesses in the
floor by placing wood, pasteboard or such like.
The front adjustable feet must be blocked after instal-
lation of the appliance by means of the locking nuts.
Levelling
It is essential that your machine is absolutely level.
Raise or lower the front feet of the machine; tighten
the nuts of the feet with your hand or an adjustable
wrench.
Also make sure that the machine does not touch the
wall, the furnitures etc. during the functioning. This in
order to avoid vibrations, noise or displace-ments of
the appliance during operation.
- 17 -
Hide quick links:
Advertisement
Table of Contents
