Command Line - Supermicro SSE-X3348S/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches

Command Line

Configuring the switch can be done using a command line via telnet or by using the
serial console interface.
Accessing CLI through Telnet
To access the command line via telnet, follow the below steps.
1. Connect a PC to a network that is accessible to the switch.
For example, connect a PC to any of the front panel ports of the switch and make
sure the PC has an IP address on the same subnet as the switch management IP.
2. In the PC, start a telnet client session with the switch management IP (default IP is
192.168.100.102).
This brings up the switch's command line interface for user login.
3. Enter the default username (ADMIN) and password (ADMIN) to login to the switch.
4. To view the switch configurations use show commands and to configure the switch
type config term to get access to the configuration commands. For help type ? or
help.
Accessing CLI through a Serial Console
To access the command line via a serial console, follow the steps below.
1. Connect a PC serial port to the switch console port.
2. In the PC, open any serial port access applications, such as Hyperterminal or Term
Term.
3. Choose the serial port connected with the switch and configure with the following
parameters:
Baudrate = 9600
Data bits = 8
Parity = None
Stop bit = 1
4. This brings up the switch's command line interface for user login.
5. Enter username and password to login to the switch.
6. To view the switch configurations use show commands and to configure the switch
type config term to get access to the configuration commands. For help type ? or
help.
For further information on the use of the command line interface, see the separate CLI
User's Guide manual on your enclosed CD-ROM.
3-2