Chapter 1 Introduction; Introduction; Overview - Supermicro SSE-X3348S/R User Manual

1-1

Introduction

This document is designed to provide Supermicro Switch users with the information
required to configure the basic functionalities on the switch through the Web graphical
user interface (GUI).
Supermicro Switch products can be configured through Web browsers like Internet
Explorer or Mozilla Firefox. To manage a switch through a web browser, type in the
management IP address in the web browser address bar. This will allow you to start
accessing the switch. For example, if the management IP address of the switch is
192.168.100.102, the switch can be accessed through the Web browser by typing http:/
/192.168.100.102 in the address bar of the web browser.
NOTE: Most of the contents of this manual apply to all of these seven switch
products:
•
•
•
•
•
•
•
In a few sections the contents differ for these products. In those specific places,
the applicable product is clearly identified. So if any particular product is not
mentioned, you can assume that the contents are valid for these six products.
1-2

Overview

Both the SSE-G24-TG4 and the SSE-G48-TG4 1/10-Gigabit Ethernet Layer 2/3
switches include two bays for up to four 10-Gb/s uplink ports (one or two dual-port CX4
modules and/or one or two dual-port XFP modules and/or one or two dual port SFP+
modules), and either 24 (SSE-G24-TG4) or 48 (SSE-G48-TG4) duplex 1-Gb/s (RJ45)
ports for LAN interfaces (of which four are combo ports that can alternately be
connected to SFP cables with an appropriate transceiver). These Ethernet switches also
have an external serial connector for connecting to an external console.
Chapter 1
Introduction
SSE-G24-TG4
SSE-G48-TG4
SSE-X24S/R
SSE-X3348S/R
SBM-GEM-X2C
SBM-GEM-X2C+
SBM-XEM-X10SM
1-1