Advertisement
CAUTION:
TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the
toy and battery manufacturers' instructions;
2. Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT:
BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and
back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of
battery. Always remove from the product before recharging. Recharge
batteries under adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
3
STEP 2
Install one or more crystals
into the chamber in the hilt.
Each crystal causes the lightsaber
CRYSTAL
to emit a different sound. After you
always switch, add or remove crystals.
Color Chart:
Red: red crystal
Blue: blue crystal
Green: green crystal
Aqua: blue and green crystals
Orange: red and green crystals
Purple: red and blue crystals
Note: If the crystals become
misplaced or lost, turn the power
on and off (see "Power Up" section
below) to cycle through the
different blade colors and sounds.
complete your lightsaber, you can
Store the extra crystals
in the storage chamber.
4
Advertisement
