Zanussi FLS421C Instructions Manual page 11

6. Start
Before pulling the On/off knob check if:
The door is properly closed.
The appliance is plugged in.
The water supply tap is turned on.
The drain filter is tight.
The drain hose is adequately positioned.
Pull the program dial up to you till it klicks.
The pilot light comes on and the program will
begin.
7. Stop
The washing machine stops automatically once
the cycle is finished, the pilot goes out. Open
the door 2 to 3 minutes after the end of the
program to give the safety device time to
unlock.
Push the knob close the tap and unplug the
appliance. Leave the door ajar for a few minutes
for the steam to get out.
IMPORTANT REMARK: This appliance is
provided with a security device to avoid
opening during the cycles. Open it only
when absolutely necessary and wait 2 to 3
minutes after you have stopped the
machine to give the safety device time to
unlock.
28
P0215
ALO26