Installing The First Projector (Set A); Deciding Installation Position; Setting Up Set A - Hitachi CP-X8150 User Manual

2.2 Installing the first projector (Set A)

Deciding installation position

Decide the position of Set A and its projection angle.
→ Arrangement
WARNING ►Only for CP-X8160, CP-WX8255 and CP-WU8450, it is possible
to install the projector for any direction with specified mounting accessories.
Consult with your dealer about such a special installation.
• Set the tilt angle of Set A to within 9 degrees from the level line.
NOTE

Setting up Set A

1.
Turn on Set A.
2.
Perform the INSTALLATION setting first if necessary as it may change the
image position.
3.
Adjust the image of Set A to fit the screen with the ZOOM, FOCUS and LENS
SHIFT features.
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating Guide
• KEYSTONE cannot be operated when PERFECT FIT is in use.
NOTE
To adjust the image using both KEYSTONE and PERFECT FIT, adjust
KEYSTONE first.
• If you are using Simple Stack, go to
B). ( 8 )
(Set
(continued on next page)
and Adjusting the projector's
(Operating Guide
(Operating Guide
→ EASY MENU
(User's Manual (concise)
elevator)
→ SETUP menu
→ Adjusting the
or SETUP menu)
2.3 Installation of the second projector
6
Installation
)
lens)