Zanussi FLS1000C Instructions Manual page 7

6. Start
Before pulling the program selector check if:
The door is properly closed.
The appliance is plugged in.
The water supply tap is turned on.
The drain filter is tight.
The drain hose is adequately positioned.
Pull the program dial towards you till it clicks.
The on/off lamp light comes on and the program
will begin.
7. Stop
The washing machine stops automatically once
the cycle is finished, the on/off lamp goes off.
Open the door 3 minutes after the end of the
program to give the safety device time to
unlock.
Push the program selector in, close the tap, and
unplug the appliance. Leave the door ajar for a
few minutes for the steam to get out.
IMPORTANT REMARK: This appliance is
provided with a security device to avoid
opening during the cycles. Open it only
when absolutely necessary and wait 3
minutes after you have stopped the
machine to give the safety device time to
unlock.
24
P0215
ALO26