Programme Information - Zanussi FE 1205 Instruction Booklet

132990110•gb 17-11-2003 9:42
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET
previously performed programme (three blinking
dashes will appear on the display);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• RINSES
Depress RESET
goes out.
• SPIN
Depress RESET
and RINSES go out.
• DRAIN
Depress RESET
WASH, RINSES and SPIN go out.
Example:
• If the machine is switched off:
- depress ON/OFF button to switch it on;
- select the type of fabric by means of button
FABRIC:
- select the special programme as previously
described.
Pagina 11
once or repeatidly to cancel the
once, the pilot light WASH
twice, the pilot lights WASH
three times, the pilot lights
In this case the
machine will perform
the rinses and spin.
10 DELAY button
This button makes it possible to delay the starting of
the programme by up to 23 hours. The delay you
have selected is shown on the display for about
3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to change or cancel the delay
time, proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button until the display shows the
desired delay time or
• press the DELAY button once, to erase the delay
time. The display will indicate "0h".
• press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button. After you have closed the
door, press the START/PAUSE button again.
11 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried
out will remain lit.
11